What problems can be troubleshooted with Meter/CT Self-Check Function?

These installation problems need to be Manually Corrected by the installer:
① 'CT' has not been successfully clipped on the phase wire
② 'CT' is wrongly connected to the loads side
③ 'CT' is wrongly connected between the loads and the inverter
④ The CT is connected to the N wire
⑤ Two CTs are connected to the same phase.
⑥ The CT is connected to 2 wires
⑦ The direction of ‘Meter-CT’ is reversed
⑧ ‘Meter-CT’ three phases correspondence is not correct
If you want to know more about meter/ct Self Check function, please refer to this link:https://kb.solaxpower.com/solution/detail/2c9fa4148adb360e018b4061d11c0394
Note: Meter’s direction reverse problem also need to be Manually